top of page

What to expect during a Session

Environment

The practitioner will first assess whether there’s any reason not to start a biophoton session. Then an interview follows to obtain a general picture of the imbalances experienced by the client. 

 

Interview

Treatments take place while comfortably seating in a warm office environment generally fully clothed except for exposure of the hands and feet upon which most of the treatments take place.  

 

How Would Your Life Be 

If You Were Free From Medication And Suffering? 

 

Explore Biophoton Therapy

for yourself. 

 

LEARN MORE

Measurement

Skin resistance measurement is first performed on what are known as the Voll Acupuncture points, (approximately 110) located on the hands and feet.  Each point is located on individual meridians which act as "energy highways" based on Classical Chinese Medicine. Each meridian corresponds to a specific organ or gland. This measurement gives an overall picture of what organ systems are affected energetically. Occassionally whiplash or a condition that’s referred to as electron spin-inversion is present which prevent measurement. When these conditions are found the client is treated for them first. Then accurate measurements can be taken.  The practitioner will explain what environmental causes there might be for the spin-inversion and how it can be prevented or corrected in the future.

Testing remedies

Now, informational remedies are tested that might balance the body out. This involves testing (measuring on the points) for every remedy that is chosen by the practitioner and added to the list in the Chiren™.

 

Hand treatment

A treatment with glass rods in both hands is carried out. The Chiren™ receives the body’s biophoton emission through the rod held in the right hand. Inside the instrument the body’s coherent light is amplified, while the chaotic light is inverted. The light is then sent back to the body via the glass rod held in the left hand. This rod can be recognized by a blue light.

Second measurement and testing round

After the hand treatment, another measurement follows, and, if necessary, new remedies are tested.

Footplate treatment

Finally, two glass plates are placed underneath the feet to run a program that takes about 17 minutes. Children under 12 usually don’t get a footplate treatment, but sometimes a second short hand treatment is given if necessary.

Third measurement round

After the footplate treatment another measurement is carried out, which is the final check-up.

Assessment and Balancing Meridians

Measurements are taken of energy that exists in the non-physical realm. What is measured energetically is not always manifested or visible in the physical, and some physical disturbances that are manifested are not measurable. The aim of this treatment is to release energetic blockages and disturbances in the body that may have come from either physical or emotional trauma to restore the body's own self-healing capacity.

 

Interpretation

Through research and practice Biontologists often recognize patterns and correlations. This allows them to share a personal interpretation of what might be causitive in a disease, which can be very accurate. These interpretations are not diagnoses.

 

Time

During the full session, which typically lasts an hour or more, the practitioner is with you in the room. Observation and conversation are an important part of Biontology.

 

No additional therapeutics

Apart from the biofeedback treatment with the body’s own light, the Biontologist uses no other means to manipulate the physical or energetic body. No supplements, (medical) drugs*, homeopathic remedies, crystals, energetic devices, other therapies etc. are added, since they will all interfere with the body’s own course of healing initiated by the light treatment, and delay or even block results.

 

*Biophoton treatment can still be applied effectively for clients currently taking doctor-prescribed medications and we do not generally recommend any changes to existing prescriptions, but it is to be expected that more sessions than average are required.

 

How many sessions

Providing there’s no interference of other physical or energetic treatment (see previous section) or environmental disturbances, a client typically needs 4-12 sessions to completely restore biophoton coherence.

 

The first 2 treatments should take place within 4-5 days apart. After this, the frequency is typically 7 days apart although it is possible to be scheduled anywhere from 5 -7 days apart if recommended by the therapist. The sessions are there to initiate the self-healing action. For the healing itself, the body needs time and rest. This is why the break between sessions is important. 

 

bottom of page